This electronic part is conveniently packaged in 16-TSSOP (0.173, 4.40mm Width), making it easy to ship abroad. Advanced packaging method Tape & Reel (TR) is used to provide high reliability. This analog switch is mounted in Surface Mount. Multiplexers and demultiplexers have the same number of circuits 4:1. An extended operating temperature of -40°C~125°C TA degrees Celsius. A total of 16 terminations have been recorded. The electronic part provides high-quality output because it has 4 channels. An 5V voltage supply should allow the electrical part to be turned on and run. It is part of the design of the 16 series that this electronic component is included. SP4T switching circuits are used in these analog switch ics. The circuits in this analogue multiplexer number 2. 74HC4052 can be used to search for analog multiplexer variants. It has an internal resistance of 210Ohm. Datasheets for functions of 16 pins are available. A voltage higher than 10V should not normally be supplied to the switches. Analogue multiplexers of the Dual, Single supply type that are cost-effective. There should be 2V voltage fed to the electrical part below 2V. The switch device would be able to operate with 320μA current. For this switch, a dual supply voltage is feasible, but it must not exceed 5VIf you are using a dual power supply, you should attach at least 1V. There is an integrated analog IC SINGLE-ENDED MULTIPLEXER in the module. A total of COMMON OUTPUT outputs are available on this analog switch ic. In order to operate the 8 inputs, there are several steps to follow. Drain to Source resistance for this electronic component is 225Ohm. Automotive, AEC-Q100 is a series number.