This electronic part is conveniently packaged in 6-TSSOP, SC-88, SOT-363, making it easy to ship abroad. High reliability is achieved by using advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 2:1. Around -40°C~125°C TA is the extended operating temperature. Total terminations are 6. This electronic part offers high-quality output due to its 1 channels. If the voltage supply is 3V volts, the electrical component should be turned on and run. A key feature of the 6 series is the inclusion of this electronic part as part of its design. On the other hand, analog switches can be constructed using SPDT switching circuits. Try searching with ADG749 to find analog multiplexer variants. As far as internal resistance is concerned, it has 5Ohm. The datasheets for the 6 pins explain the functions. Multiplexer or Switches is a typical switch device. Users shouldn't supply more than 5.5V voltage to the switch device. It is recommended that the electrical component receives a voltage of 1.8V. Analogue multiplexers require a 1.8V~5.5V voltage to drain from a single voltage supply. Put voltage above 1μA on the multiplexer to cause damage. There are various bandwidths available for data transfer. There is also CAN ALSO OPERATE WITH 5 VOLT SUPPLY to look out for in this electronic part. There is 5Ohm Drain to Source resistance on this electronic part. A analog switch ics with 2 outputs is included.
ADG749BKSZ-REEL7 Features
1 Channels Switch Circuit: SPDT Bandwidth: 200MHz Additional Features: CAN ALSO OPERATE WITH 5 VOLT SUPPLY Drain-to-Source resistance: 5Ohm
ADG749BKSZ-REEL7 Applications
There are a lot of Analog Devices Inc. ADG749BKSZ-REEL7 Analog Switches & Multiplexers ICs applications.
Remote Powered Equipment
Routers
PBXs
Microwave transmission systems
Relay replacements
Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads