ADG801BRMZ-REEL7 Overview

Packed in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), the electronic component is convenient for shipping overseas. High reliability is achieved by using advanced packaging method Tape & Reel (TR). Multiplexers like this are mounted in the Surface Mount position. 1:1 is the ratio of multiplexer to demultiplexer circuits. Operational temperature extended around -40°C~125°C TA. The total number of terminations is 8. The electronic part provides high-quality output because it has 1 channels. Powered by a 3V voltage supply, the electrical part should be switched on and run. A total of 8 pins are injected into the electrical part body. Multiplexers built on a SPST - NO switching circuit are built. ADG801 can be used to search for analog multiplexer variants. There is 300mOhm internal resistance in this digital multiplexer. The datasheets for the 8 pins explain the functions. The analogue multiplexer in this example is a typical Multiplexer or Switches. Users shouldn't supply more than 5.5V voltage to the switch device. Digital switch that provides Single power at a cost-effective price. 1.8V is the lowest voltage that should be fed to the electronic electronic part. An operating current of 1nA would be sufficient for this switch device. A voltage of 1.8V~5.5V is required to drain this analog switch from a single voltage supply. When the digital multiplexer is charged above 1μA, damage can occur. The transfer of data can be performed over 12MHz bandwidths.

ADG801BRMZ-REEL7 Features

1 Channels
Switch Circuit: SPST - NO
1nA Supply Current
Bandwidth: 12MHz

ADG801BRMZ-REEL7 Applications

There are a lot of Analog Devices Inc. ADG801BRMZ-REEL7 Analog Switches & Multiplexers ICs applications.

• Wireless Local Loop
• ISDN NT1/TA
• High-Voltage
• Signal routing between systems
• Voice over IP/DSL – Integrated Access Devices, Smart
• CSU
• Microwave transmission systems
• Routers
• Audio/video switches
• Relay Replacement