ADG813YRUZ Overview

As the electronic part is packed in 16-TSSOP (0.173, 4.40mm Width), international shipping is convenient. This high-reliability packaging method uses advanced packaging methods Tube. There is an analog multiplexer mounted in position Surface Mount. Multiplexers and demultiplexers have a number of circuits 1:1. Operational temperature extended around -40°C~125°C TA. In total, there are 16 terminations. The electronic part provides high-quality output because it has 4 channels. Powered by a 2.5V voltage supply, the electrical part should be switched on and run. It is injected into the electrical part body with 16 pins. Multiplexers built on a SPST - NO/NC switching circuit are built. Search with ADG813 if you are looking for analog multiplexer variants. Analog switches have 650mOhm internal resistance. You can find the functions of the 16 pins in the datasheets. Multiplexer or Switches is a typical switch device. It is normally recommended that users do not supply the multiplexer with voltages higher than 3.6V. A cost-effective Single supply type analogue multiplexer. 1.65V is the lowest voltage the electrical component should receive. A voltage of 1.65V~3.6V is required to drain this analog switch from a single voltage supply. A digital multiplexer may suffer damage if voltage is applied above 4μA. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. Operating voltages of 3V are compatible with the electrical part. This electronic component presents a Drain to Source resistance of 650mOhm.

ADG813YRUZ Features

4 Channels
Switch Circuit: SPST - NO/NC
-3db Bandwidth: 90MHz
Drain-to-Source resistance: 650mOhm

ADG813YRUZ Applications

There are a lot of Analog Devices Inc. ADG813YRUZ Analog Switches & Multiplexers ICs applications.

• Mechanical reed relay replacement
• Precision instrumentation
• Multiplexers
• Intelligent PBX
• RGB switches
• Cell phones
• Remote wireless modules
• SONET/SDH ADM
• Avionics
• Medical Instrumentation