ADG819BRM-REEL Overview

The electronic part can be shipped overseas conveniently because it is packaged in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. Multiplexers like this are mounted in the Surface Mount position. 2:1 is the ratio between multiplexers and demultiplexers. Increasing operating temperature to around -40°C~125°C TA. There are 8 terminations totally. A 1 channel electronic part produces high-quality output. Powered by a 3V voltage supply, the electrical part should be switched on and run. A total of 8 pins are injected into the electrical part body. These analog multiplexers are built based on SPDT switching circuits. A total of 1 circuits make up this switch device. Using the ADG819 search parameter, you can discover variants of the switch. An switch multiplexer with 600mOhm internal resistance has a value of 600mOhm. The datasheets for the 8 pins explain the functions. The analogue multiplexer in this example is a typical Multiplexer or Switches. Users should never supply a voltage higher than 5.5V to a switch device. Analogue multiplexer with a Single supply type that is cost-effective. A low voltage of 1.8V should be applied to the electronic component. This analog switch requires a voltage of 1.8V~5.5V to drain from a single voltage supply. A voltage higher than 2μA may cause damage to the switch multiplexer.

ADG819BRM-REEL Features

1 Channels
Switch Circuit: SPDT
-3db Bandwidth: 17MHz

ADG819BRM-REEL Applications

There are a lot of Analog Devices Inc. ADG819BRM-REEL Analog Switches & Multiplexers ICs applications.

• Signal routing between systems
• Remote wireless modules
• Battery Powered Systems
• ISDN NT1/TA
• Medical
• Medical systems
• New designs requiring multiplexer functions
• DVD-R
• Channel Banks
• Microprocessor Controlled Analog Systems