Presented in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), this electrical component is convenient for overseas shipping. Advanced packaging method Tape & Reel (TR) is used to provide high reliability. In Surface Mount, you'll find this switch device. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. The operating temperature is extended to around -40°C~125°C TA. There are 8 terminations totally. High-quality output is provided by the electronic component's 2 channels. A 5V voltage supply should turn on and run the electronic component. An electrical component like this is included in the 8 series. A SPST - NC switching circuit is used for these analog switches. If you are looking for variants of the digital switch, trying search with ADG822. In this multiplexer, the internal resistance is 600mOhm. You can find the functions of the 8 pins in the datasheets. In this analog multiplexer, the value is Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. A analog switch ic that has a cost-effective Single supply type. The lowest voltage fed to the electronic component should be 1.8V. It would be sufficient to run this analogue multiplexer with 1nA current. This analogue multiplexer requires a voltage of 1.8V~5.5V when it drains from a single voltage supply. Putting voltage greater than 2μA on the multiplexer may cause damage. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. 24MHz-bandwidths can be used to transfer data between multiplexers.