ADG888YRUZ Overview

Packed in 16-TSSOP (0.173, 4.40mm Width), the electronic component is convenient for shipping overseas. A high level of reliability can be achieved through the use of an advanced packaging method Tube. Surface Mount is where this multiplexer is located. The ratio between the number of multiplexer and demultiplexer circuits is 2:2. Operation at a temperature around -40°C~125°C TA. 16 terminations have been made so far. The electronic part delivers high-quality output through its 2 channels. An 2.7V voltage supply should allow the electrical part to be turned on and run. Electronic part bodies are injected with 16 pins. A DPDT switching circuit is used to build these analog multiplexers. Search with ADG888 if you are looking for analog multiplexer variants. In this multiplexer, the internal resistance is 480mOhm. The functions of 16 pins can be found in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. Analogue multiplexers of the Single supply type that are cost-effective. It is recommended that the electrical component receives a voltage of 1.8V. This analog switch requires a voltage of 1.8V~5.5V to drain from a single voltage supply. A voltage higher than 4μA may cause damage to the switch multiplexer. It can operate from 5.5V operating voltages. In order to operate the 4 inputs, there are several steps to follow. 29MHz bandwidths enable data to be transferred. The analog switch ics includes 8 outputs.

ADG888YRUZ Features

2 Channels
Switch Circuit: DPDT
Bandwidth: 29MHz

ADG888YRUZ Applications

There are a lot of Analog Devices Inc. ADG888YRUZ Analog Switches & Multiplexers ICs applications.

• DSUs
• Medical systems
• Battery Powered Systems
• Microwave transmission systems
• Cable PC
• Video signal routing
• SDH
• Residential Gateways, Home Gateway/Router
• Battery Powered Instruments
• Intelligent PBX