AS1747-BTDT-1K Overview

Due to its 10-WFDFN Exposed Pad packaging, the electronic part is convenient for international shipping. To ensure high reliability, a new packaging method Cut Tape (CT) is used. A switch device like this is mounted in Surface Mount. Multiplexers and demultiplexers have a ratio of 2:1. Operation at a temperature around -40°C~85°C TA. Based on SPDT switching circuits, these analog multiplexers work. 2 circuits are used in this analogue multiplexer. As far as internal resistance is concerned, it has 850mOhm. For functions related to 10 pins, please refer to the datasheets. It is normally recommended that users do not supply the multiplexer with voltages higher than 5.5V. The analog switch ic is of the Single supply type and is cost-effective. 1.8V is the lowest voltage the electrical component should receive. The analogue multiplexer could operate on 10nA current. Using a single voltage supply, this switch device consumes 1.8V~5.5V volts. Put voltage above 1μA on the multiplexer to cause damage.

AS1747-BTDT-1K Features

Switch Circuit: SPDT
10nA Supply Current
-3db Bandwidth: 31MHz

AS1747-BTDT-1K Applications

There are a lot of ams AS1747-BTDT-1K Analog Switches & Multiplexers ICs applications.

• Relay Replacement
• Frame Relay Equipment
• Communication systems
• Channelized and Unchannelized DS3 applications
• Residential Gateways, Home Gateway/Router
• Audio signal routing
• Remote wireless modules
• Fiber In The Loop (FITL)
• Channel Banks
• T1/E1 Terminals