Presented in 16-SOIC (0.154, 3.90mm Width), this electrical component is convenient for overseas shipping. To ensure high reliability, a new packaging method Tube is used. It is mounted in the position Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. Around -40°C~85°C TA is the extended operating temperature. 16 terminations have been made so far. This electronic part offers high-quality output due to its 4 channels. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. The electronic part body is injected with 16 pins. A SPST - NC switching circuit is used for these analog switches. Try searching for the analog switch ic with DG411 if you are looking for variants. As far as internal resistance is concerned, it has 80Ohm. Datasheets for functions of 16 pins are available. Theswitch device is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 30V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. It is recommended that the electrical component receives a voltage of 10V. For this digital switch to work, 100pA current would suffice. It may damage the digital multiplexer if the voltage is higher than 100pA. For this multiplexer, dual supply voltage is feasible, but it should not exceed 20V. In the case of dual power supplies, you should connect at least 4.5V. Operating voltages range from 20V. The Drain to Source resistance of this electronic component is 45Ohm.