PI74FCT574ATQ Overview
The flip flop is packaged in 20-SSOP (0.154, 3.90mm Width). A package named Tubeincludes it. It is configured with Tri-State, Non-Invertedas an output. Positive Edgeis the trigger it is configured with. It is mounted in the way of Surface Mount. A voltage of 4.75V~5.25Vis used as the supply voltage. In the operating environment, the temperature is -40°C~85°C TA. The type of this D latch is D-Type. JK flip flop is a part of the 74FCTseries of FPGAs. There are 1 elements in it. As a result, it consumes 500μA quiescent current. You can search similar parts based on 74FCT574. There is 6pF input capacitance for this T flip flop. Surface Mount mounts this electronic component. The 20pins are designed into the board. It has a clock edge trigger type of Positive Edge. 8bits are used in its design. Despite its superior flexibility, it relies on 8 circuits to achieve it. For high efficiency, the supply voltage should be kept at 5V. A high level output current of -15mAis set. In the low level output current setting, 64mAis used. It is recommended that the operating temperature be below 85°C. It is recommended that the operating temperature is higher than -40°C. Initially, it requires a voltage of 4.75V as the minimum supply voltage. It supports a maximum supply voltage of 5.25V volts.
PI74FCT574ATQ Features
Tube package
74FCT series
20 pins
8 Bits
PI74FCT574ATQ Applications
There are a lot of Diodes Incorporated PI74FCT574ATQ Flip Flops applications.
- Storage registers
- Data storage
- Automotive
- Control circuits
- Individual Asynchronous Resets
- 2 – Bit synchronous counter
- High Performance Logic for test systems
- Frequency Dividers
- Guaranteed simultaneous switching noise level
- Modulo – n – counter
