EL5421TIYZ-T7 Overview

A MSOP case is used to package the op amp. BUFFER-type instrumentation amplifiers are used in this application. It is estimated that there will be 10 terminations in the next few months. There are a total of 10 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 5V volts. There are 10 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 4mV. An 550μA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. There are 4 channels on the operational amplifiers. In order for op amp to function properly, the temperature should not be lower than -40°C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 85°C. The operating supply voltage of the buffer op amp is rated at 18V. I would like to point out that this electrical component is capable of working from a voltage below 19V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 4.5V at all times. The dual supply voltage of 9.5V should be used for the conduct of this electronic component.

EL5421TIYZ-T7 Features

10 Pins
supply voltage of 5V
0.069dB voltage gain

EL5421TIYZ-T7 Applications

There are a lot of Intersil (Renesas Electronics America)
EL5421TIYZ-T7 Instrumentational OP Amps applications.

• Addition operation circuits
• Subtraction operation circuits
• single/dual op amp sum and difference circuits
• Integrator circuits
• Differentiator circuits
• Logarithmic operation circuits
• Exponential operation circuits
• Multiplication circuits
• Division circuits
• Precision measurement