DG306ACJ Overview

Shipping overseas is convenient with the electronic component packed in 14-DIP (0.300, 7.62mm). A high level of reliability can be achieved through the use of an advanced packaging method Tube. A switch device like this is mounted in Through Hole. 2:1 is the number of circuits in the multiplexer and demultiplexer. Operational temperature extended around 0°C~70°C TA. Total terminations are 14. The electronic part delivers high-quality output through its 2 channels. A 15V voltage supply should turn on and run the electronic component. As part of its design, the 14 series is equipped with this electronic component. Circuits based on DPST - NO switching are used to construct these analog switch ics. Circuits number 2 make up this analogue multiplexer. Try searching with DG306A to find analog multiplexer variants. This digital multiplexer has 50Ohm internal resistance. For details about the functions of 14 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 36V. 10V is the lowest voltage the electrical component should receive. For this switch, a dual supply voltage is feasible, but it must not exceed 18VWith dual power supplies, you should attach at least 5V. In this switch multiplexer, there are SEPARATE OUTPUT outputs available.

DG306ACJ Features

2 Channels
Switch Circuit: DPST - NO

DG306ACJ Applications

There are a lot of Maxim Integrated DG306ACJ Analog Switches & Multiplexers ICs applications.

• Audio and video routing
• Precision instrumentation
• Digital Cross-Connects
• Isolation
• Data switching
• PBX interfaces
• PCMCIA cards
• SDH
• SDH/SONET multiplexers
• Battery Powered Instruments