DG412DY+ Overview

Shipping overseas is convenient with the electronic component packed in 16-SOIC (0.154, 3.90mm Width). High reliability is provided by advanced packaging method Tube. In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 1:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 16. High-quality output is provided by the electronic component's 4 channels. If the voltage supply is 15V volts, the electrical component should be turned on and run. The electronic part body is injected with 16 pins. A SPST - NO switching circuit is used to build these analog multiplexers. Try searching with DG412 if you're looking for variants. There is 80Ohm internal resistance in this digital multiplexer. For functions related to 16 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 30V should not normally be supplied to the switches. Analogue multiplexers of the Dual, Single supply type that are cost-effective. 10V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 100pA current would be sufficient. The analogue multiplexer may be damaged if voltage is greater than 1μA. If put voltage greater than 20V on the multiplexer, damage may be caused to the device. If you are using dual power supplies, you should attach at least 4.5V. 20V operating voltages are supported by the electronic component. Drain to Source resistance is 45Ohm.

DG412DY+ Features

4 Channels
Switch Circuit: SPST - NO
100pA Supply Current
Drain-to-Source resistance: 45Ohm

DG412DY+ Applications

There are a lot of Maxim Integrated
DG412DY+ Analog Switches & Multiplexers ICs applications.

• Transmit
• Low-Voltage
• Isolation
• Medical
• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems