DG419DJ+ Overview

Due to its 8-DIP (0.300, 7.62mm) packaging, the electronic part is convenient for international shipping. To ensure high reliability, a new packaging method Tube is used. Through Hole is where this multiplexer is located. Multiplexers and demultiplexers have the same number of circuits 2:1. Operational temperature extended around -40°C~85°C TA. Totally, there are 8 terminations. The electronic part delivers high-quality output through its 1 channels. When the electronic component is given a voltage of 15V, it should be turned on and run. An electrical component of this type can be found in the 8 series. SPDT switching circuits are used in these analog switch ics. Look for analog switch ic variants by searching with DG419. The internal resistance of this digital multiplexer is 35Ohm. The datasheets for the 8 pins explain the functions. This switch device is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 30V. Analog switch ics with Dual, Single supply type are cost-effective. The lowest voltage the electronic part should receive is 10V. It would be sufficient to run this analogue multiplexer with 100pA current. Putting voltage greater than -100pA on the multiplexer may cause damage. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 20V. A dual power supply should have at least 4.5V voltage attached. A voltage of 20V can be used to operate the electronic component.

DG419DJ+ Features

1 Channels
Switch Circuit: SPDT
100pA Supply Current

DG419DJ+ Applications

There are a lot of Maxim Integrated DG419DJ+ Analog Switches & Multiplexers ICs applications.

• HDTV
• Routers
• Residential Gateways, Home Gateway/Router
• Battery Powered Instruments
• Avionics
• Isolation
• Video signal routing
• Microwave transmission systems
• Medical Instrumentation
• Remote Powered Equipment