The electronic part can be shipped overseas conveniently because it is packaged in 8-DIP (0.300, 7.62mm). In order to provide high reliability, an advanced packaging method Tube is used. There is an analog multiplexer mounted in position Through Hole. There is 2:1 ratio between the number of multiplexers and demultiplexers. Around 0°C~70°C TA is the extended operating temperature. In total, there are 8 terminations. This electronic part offers high-quality output due to its 1 channels. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. There are 8 pins injected into the electronic part body. The analog switch ics are built using SPDT switching circuits. Search with MAX319 if you are looking for analog multiplexer variants. It has an internal resistance of 35Ohm. The functions of 8 pins can be found in the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. In normalcircumstances, users should not exceed 30V volts for the multiplexer. Dual, Single supply type digital switch with a low cost. 10V is the lowest voltage that should be fed to the electronic electronic part. In order to operate this switch device, it would need a current of 1μA. A digital multiplexer may suffer damage if voltage is applied above 100pA. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 20V. In the case of dual power supplies, you should connect at least 4.5V. There is a voltage range of 20V operating voltages for the electrical part. The Drain to Source resistance of this electronic component is 35Ohm.