The electrical component comes in 16-TSSOP (0.173, 4.40mm Width) packaging, which makes it convenient to ship overseas. Advanced packaging method Tube is used to provide high reliability. Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have a number of circuits 1:1. Operating temperature around 0°C~70°C TA extended. The total number of terminations is 16. Due to its 1 channels, the electrical component produces high-quality output. With a 5V voltage supply, the electrical component should be turned on and run. This electrical component is included in the 16 series of products. Based on SPST - NO/NC switching circuits, these analog multiplexers work. It consists of 4 circuits. MAX393 can be used to search for analog multiplexer variants. As far as internal resistance is concerned, it has 35Ohm. Please refer to the datasheets for 16 pins functions. This switch device is a typical Multiplexer or Switches. Multiplexers should not be powered above 15V in normal situations. The analog switch ic is of the Dual, Single supply type and is cost-effective. The lowest voltage fed to the electronic component should be 3V. This multiplexer would work with 1μA current. It may damage the digital multiplexer if the voltage is higher than 1μA. For this switch, a dual supply voltage is feasible, but it must not exceed 8VA dual power supply should have at least 3V voltage attached. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. It can operate from 8V operating voltages.
MAX393CUE Features
1 Channels Switch Circuit: SPST - NO/NC 1μA Supply Current
MAX393CUE Applications
There are a lot of Maxim Integrated MAX393CUE Analog Switches & Multiplexers ICs applications.
Existing multiplexer applications (both fault-protected and nonfault-protected)