MAX4515CPA Overview

The electronic part can be shipped overseas conveniently because it is packaged in 8-DIP (0.300, 7.62mm). High reliability is provided by advanced packaging method Tube. There is an analog multiplexer mounted in position Through Hole. Multiplexer and demultiplexer circuits have a number 1:1. Increasing operating temperature to around 0°C~70°C TA. 8 terminations have been made so far. High-quality output is provided by the electronic component's 1 channels. When the electronic component is given a voltage of 5V, it should be turned on and run. It is part of the design of the 8 series that this electronic component is included. Circuits based on SPST - NC switching are used to construct these analog switch ics. A total of 1 circuits make up this switch device. If you are looking for variants of the digital switch, trying search with MAX4515. There is 10Ohm internal resistance in this digital multiplexer. In this analog multiplexer, the value is Multiplexer or Switches. A cost-effective Single supply type analogue multiplexer. For this multiplexer to operate, 2μA current would be sufficient. A voltage of 2V~12V is required for this switch device, which drains from a single voltage source.

MAX4515CPA Features

1 Channels
Switch Circuit: SPST - NC
2μA Supply Current

MAX4515CPA Applications

There are a lot of Maxim Integrated MAX4515CPA Analog Switches & Multiplexers ICs applications.

• Audio signal routing
• Fault Tolerant Systems
• Residential Gateways, Home Gateway/Router
• Ultrasound
• Transmit
• SDH/SONET multiplexers
• Cable Telephony – NIU, Set-Top Box, Home Side Box
• Sample-and-hold systems
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• Audio and video switching