MAX4519CPD+ Overview

Presented in 14-DIP (0.300, 7.62mm), this electrical component is convenient for overseas shipping. Multiplexers and demultiplexers have a ratio of 2:1. Increasing operating temperature to around 0°C~70°C TA. The total number of terminations is 14. Due to its 2 channels, the electrical component produces high-quality output. An 5V voltage supply should allow the electrical part to be turned on and run. There is an electrical component included in the 14 series. Circuits based on DPST - NO switching are used to construct these analog switch ics. This multiplexer is composed of 2 circuits. This digital multiplexer has 100Ohm internal resistance. Datasheets for 14 pin functions are available upon request. Users shouldn't supply more than 15V voltage to the switch device. In order for the electronic part to function properly, the lowest voltage should be 2.7V. Despite this switch device's dual supply capability, its voltage should not exceed 8V. In the case of dual power supplies, you should connect at least 2.7V. A DIFFERENTIAL MULTIPLEXER analog IC is integrated into the board.

MAX4519CPD+ Features

2 Channels
Switch Circuit: DPST - NO

MAX4519CPD+ Applications

There are a lot of Maxim Integrated MAX4519CPD+ Analog Switches & Multiplexers ICs applications.

• Fault Tolerant Systems
• Relay replacements
• SONET
• Cellular phones
• Voice over IP/DSL – Integrated Access Devices, Smart
• Residential Gateways, Home Gateway/Router
• T1/E1 Terminals
• Avionics
• DVD-R
• Existing multiplexer applications (both fault-protected and nonfault-protected)