MAX4615EUD+T Overview

Packed in 14-TSSOP (0.173, 4.40mm Width), the electronic component is convenient for shipping overseas. High reliability is achieved by using advanced packaging method Tape & Reel (TR). In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have a ratio of 1:1. Around -40°C~85°C TA is the extended operating temperature. In total, there are 14 terminations. A electrical component with 1 channels is capable of high-quality output. With a 3.3V voltage supply, the electrical component should be turned on and run. An injection of 14 pins is performed into the body of the electrical component. Unlike digital switches, these are based on SPST - NC switching circuits. 4 circuits are used in this analogue multiplexer. Look for analog switch ic variants by searching with MAX4615. Internally, this switch multiplexer has a resistance of 10Ohm. To find out what the 14 pins do, please refer to the datasheets. This switch device is a typical Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 5.5V to the switch device in normal circumstances. The digital multiplexer has a low cost Single supply. 2V is the lowest voltage that should be fed to the electronic electronic part. The switch device would be able to operate with 1μA current. The voltage required by this switch device is 2V~5.5V, draining from a single voltage supply. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. The electrical part can be operated at 5V voltage levels.

MAX4615EUD+T Features

1 Channels
Switch Circuit: SPST - NC
1μA Supply Current
-3db Bandwidth: 70MHz

MAX4615EUD+T Applications

There are a lot of Maxim Integrated MAX4615EUD+T Analog Switches & Multiplexers ICs applications.

• Channelized and Unchannelized DS3 applications
• Precision test equipment
• Microprocessor controlled systems
• Precision instrumentation
• FTTH
• Audio and video signal routing
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• Cell phones
• Remote Powered Equipment
• MP3 players