SY10EP51VKG-TR Overview
In the form of 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), it has been packaged. D flip flop is included in the Tape & Reel (TR)package. As configured, the output uses Differential. It is configured with a trigger that uses Positive, Negative. There is an electronic component mounted in the way of Surface Mount. A supply voltage of -3V~-5.5V is required for operation. A temperature of -40°C~85°C TAis used in the operation. This electronic flip flop is of type D-Type. It is a type of FPGA belonging to the 10EP series. This D flip flop should not have a frequency greater than 3GHz. Terminations are 8. JK flip flop belongs to 10EP51 family. It is powered from a supply voltage of 3.3V. 10Eis the family of this D flip flop. The electronic part is mounted in the way of Surface Mount. A total of 8pins are provided on this board. In this device, the clock edge trigger type is Positive Edge. The flip flop is designed with 1bits. It reaches 5.5Vwhen the maximum supply voltage (Vsup) is applied. A normal operating voltage (Vsup) should remain above 3V. To achieve this superior flexibility, 1 circuits are used. It consumes 40mA current. In addition, you can refer to the additinal NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V of the D latch. -50mAis set as the high level output current. In the low level output current setting, 50mAis used.
SY10EP51VKG-TR Features
Tape & Reel (TR) package
10EP series
8 pins
1 Bits
SY10EP51VKG-TR Applications
There are a lot of Microchip Technology SY10EP51VKG-TR Flip Flops applications.
- Convert a momentary switch to a toggle switch
- Count Modes
- Divide a clock signal by 2 or 4
- QML qualified product
- Latch-up performance
- Frequency Divider circuits
- Data Synchronizers
- Parallel data storage
- Computing
- Common Clocks
