Due to its 16-SOIC (0.154, 3.90mm Width) packaging, the electronic part is convenient for international shipping. Advanced packaging method Tape & Reel (TR) is used to provide high reliability. It is mounted in the position Surface Mount. Multiplexer and demultiplexer circuits have a number 8:1. An extended operating temperature of -40°C~125°C TA degrees Celsius. In total, there have been 16 terminations. This electronic part offers high-quality output due to its 8 channels. With a 5V voltage supply, the electrical component should be turned on and run. There is an electrical component included in the 16 series. 1 circuits are used in this analogue multiplexer. Try searching for 74HC4051 variants of the analog switch ic. In this multiplexer, the internal resistance is 140Ohm. For details about the functions of 16 pins, please refer to the datasheets. Multiplexers should not be powered above 10V in normal situations. A analog switch ic that has a cost-effective Dual, Single supply type. 2V is the lowest voltage that should be fed to the electronic electronic part. The analogue multiplexer could operate on 16μA current. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 5V. In the case of dual power supplies, you should connect at least 1V. An analog IC with the number DIFFERENTIAL MULTIPLEXER is integrated into this board. A voltage of 5V can be used to operate the electronic component. The Drain to Source resistance of this electronic component is 180Ohm. The Automotive, AEC-Q100 series includes it.