This electronic part is conveniently packaged in 16-SOIC (0.154, 3.90mm Width), making it easy to ship abroad. High reliability is ensured by the advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. The ratio between the number of multiplexer and demultiplexer circuits is 4:1. The operating temperature is extended to around -40°C~125°C TA. Total terminations are 16. The electronic part delivers high-quality output through its 4 channels. With a 5V voltage supply, the electrical component should be turned on and run. A total of 16 pins are injected into the body of the electronic part. Unlike digital switches, these are based on SP4T switching circuits. There are 2 circuits in this switch device. Look for analog switch ic variants by searching with 74HC4052. This digital multiplexer has 210Ohm internal resistance. The datasheets for the 16 pins explain the functions. In a normalsituation, users should not supply the switches with voltage higher than 10V. An effective Dual, Single supply digital multiplexer. There should be 2V voltage fed to the electrical part below 2V. In order to operate this switch device, it would need a current of 320μA. There is no problem with using dual supply voltage, but it should not exceed 5V. You should attach at least 1V voltage if you are using dual power supply. A SINGLE-ENDED MULTIPLEXER analog IC is integrated into the board. As far as the outputs go, this switch multiplexer utilizes COMMON OUTPUT of them. It is possible to operate 8 inputs. This electronic component presents a Drain to Source resistance of 225Ohm. The Automotive, AEC-Q100 series contains it.