The electronic part can be shipped overseas conveniently because it is packaged in 16-TSSOP (0.173, 4.40mm Width). High reliability is provided by advanced packaging method Tape & Reel (TR). This analog switch is mounted in Surface Mount. Multiplexers and demultiplexers have a ratio of 4:1. Operating temperature around -40°C~125°C TA extended. There are 16 terminations totally. A 8 channel electronic part produces high-quality output. If the voltage supply is 5V volts, the electrical component should be turned on and run. It is injected into the electrical part body with 16 pins. SP4T switching circuits are used in these analog switch ics. The multiplexer consists of 2 circuits. Try searching for the analog switch ic with 74HCT4052 if you are looking for variants. As far as internal resistance is concerned, it has 210Ohm. To find out what the functions of 16 pins are, please refer to their datasheets. Multiplexers should not be powered above 5.5V in normal situations. Analog switch ics with Dual, Single supply type are cost-effective. There should be 4.5V voltage fed to the electrical part below 4.5V. An operating current of 320μA would be sufficient for this switch device. For this multiplexer, dual supply voltage is feasible, but it should not exceed 5V. A dual power supply should have at least 1V voltage attached. An analog IC with the number SINGLE-ENDED MULTIPLEXER is integrated into this board. A total of COMMON OUTPUT outputs are available on this analog switch ic. It can operate from 5V operating voltages. The data can be transferred over a wide range of bandwidths, called 180MHz bandwidths. From the Automotive, AEC-Q100 series.
74HCT4052PW-Q100,1 Features
8 Channels Switch Circuit: SP4T 320μA Supply Current Bandwidth: 180MHz
74HCT4052PW-Q100,1 Applications
There are a lot of Nexperia USA Inc. 74HCT4052PW-Q100,1 Analog Switches & Multiplexers ICs applications.