Due to its 16-SOIC (0.154, 3.90mm Width) packaging, the electronic part is convenient for international shipping. High reliability is achieved by using advanced packaging method Tube. In Surface Mount, you'll find this switch device. 2:1 is the ratio of multiplexer to demultiplexer circuits. Operational temperature extended around -40°C~85°C TA. Total terminations are 16. This electronic part offers high-quality output due to its 4 channels. An 2.5V voltage supply should allow the electrical part to be turned on and run. Into the electrical component body are injected 16 pins. These analog multiplexers are built based on SPDT switching circuits. Try searching for TS3A5018 variants of the analog switch ic. This digital multiplexer has 10Ohm internal resistance. To find out what the functions of 16 pins are, please refer to their datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. In a normalsituation, users should not supply the switches with voltage higher than 3.6V. A analog switch ic that has a cost-effective Single supply type. 2.3V should be the lowest voltage fed to the electronic component. For this digital switch to work, 2.5μA current would suffice. An analogue multiplexer drains from a single voltage supply at 1.65V~3.6V. The switch multiplexer may be damaged if it is exposed to voltage greater than 7μA. 3V operating voltages can be used with this electrical part. Among the inputs that can be operated are the 4 inputs. There are various bandwidths available for data transfer. The analog switch ics has 8 outputs.
TS3A5018D Features
4 Channels Switch Circuit: SPDT 2.5μA Supply Current Bandwidth: 300MHz
TS3A5018D Applications
There are a lot of Texas Instruments TS3A5018D Analog Switches & Multiplexers ICs applications.
E1 Network Equipment
MP3 players
Central office
Audio/video switches
Microprocessor controlled systems
Industrial control systems
Cable PC
Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads