Shipping overseas is convenient due to the electrical component's packing in 16-TSSOP (0.173, 4.40mm Width). This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). A switch device like this is mounted in Surface Mount. 2:1 is the ratio of multiplexer to demultiplexer circuits. Increasing operating temperature to around -40°C~125°C TA. In total, there have been 16 terminations. A high-quality output is provided by the electrical component's 2 channels. Turning on and running the electrical part should be easy with a 2V voltage supply. Into the electrical component body are injected 16 pins. SPDT switching circuits are used in these analog switch ics. There are 3 circuits in this switch device. Try searching with 74LV4053 if you're looking for variants. Analog switches have 165Ohm internal resistance. To find out what the 16 pins do, please refer to the datasheets. Users shouldn't supply more than 6V voltage to the switch device. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended to use 1V as the lowest voltage for the electrical part. It would be sufficient to run this analogue multiplexer with 80μA current. Using only a single voltage supply, this analog switch requires 1V~6V voltage. A SINGLE-ENDED MULTIPLEXER analog IC is integrated into the board. This electrical part is compatible with 3.3V operating voltages. A 6 input needs to be operated. 200MHz-bandwidths can be used to transfer data between multiplexers. Drain to Source resistance for this electronic component is 435Ohm.