74LVC574ADB,118 Overview

As a result, it is packaged as 20-SSOP (0.209, 5.30mm Width). You can find it in the Tape & Reel (TR)package. T flip flop uses Tri-State, Non-Invertedas its output configuration. The trigger it is configured with uses Positive Edge. Surface Mountis occupied by this electronic component. Powered by a 1.65V~3.6Vvolt supply, it operates as follows. In the operating environment, the temperature is -40°C~125°C TA. This logic flip flop is classified as type D-Type. FPGAs belonging to the 74LVCseries contain this type of chip. This D flip flop should not have a frequency greater than 200MHz. In total, it contains 1 elements. As a result, it consumes 10μA of quiescent current without being affected by external factors. A total of 20terminations have been recorded. If you search by 74LVC574, you will find similar parts. A voltage of 2.7V is used as the power supply for this D latch. There is 5pF input capacitance for this T flip flop. Electronic devices of this type belong to the LVC/LCX/Zfamily. There is an electronic part mounted in the way of Surface Mount. This board is designed with 20pins on it. Its clock edge trigger type is Positive Edge. Flip flops designed with 8bits are used in this part. It reaches the maximum supply voltage (Vsup) at 3.6V. The flip flop has 2ports embedded within it. 8input lines are available for you to choose from. Quiescent current is consumed by the D latch in the amount of 100nA. In addition, you can refer to the additinal BROADSIDE VERSION OF 374 of the D latch.

74LVC574ADB,118 Features

Tape & Reel (TR) package
74LVC series
20 pins
8 Bits

74LVC574ADB,118 Applications

There are a lot of Nexperia USA Inc. 74LVC574ADB,118 Flip Flops applications.

• Frequency Divider circuits
• Computers
• Digital electronics systems
• Instrumentation
• Pattern generators
• Data storage
• Convert a momentary switch to a toggle switch
• Bounce elimination switch
• Single Up Count-Control Line
• Reduced system switching noise