74HCT174N Overview
This trigger uses the value POSITIVE EDGE. The element count is 1 . A 3.5 pFfarad input capacitance is provided by this T flip flop. It is mounted in the way of Through Hole. There are 16pins on it. The clock edge trigger type for this device is Positive Edge. The RS flip flops belongs to FF/Latches base part number. An electronic part with 6bits has been designed. In order to achieve its superior flexibility, 6 circuits are used. A power supply of 5 Vis required to operate it. If high efficiency is to be achieved, the supply voltage should be maintained at 5 V. A high level output current of -4 mAis set. In the low level output current setting, the current is set to 4 mA. Ideally, the operating temperature should be below 125 °C. If the operating temperature is higher than -40 °C, the system should operate properly. In order for it to operate, a supply voltage of 4.5 Vis required. A maximum voltage of 5.5 V can be provided by it. This frequency can be achieved at 20 MHz. There is a logic IC D FLIP-FLOP used in the D flip flop. It has 6 functions. 16pins are available on this JK flip flop.
74HCT174N Features
16 pins
6 Bits
5 V power supplies
6 Functions
16 pin count
74HCT174N Applications
There are a lot of NXP Semiconductors
74HCT174N Flip Flops applications.
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
