74ABT16374CSSC Overview

The flip flop is packaged in a case of 48-BSSOP (0.295, 7.50mm Width). The package Tubecontains it. In the configuration, Tri-State, Non-Invertedis used as the output. It is configured with the trigger Positive Edge. The electronic part is mounted in the way of Surface Mount. The JK flip flop operates at 4.5V~5.5Vvolts. In this case, the operating temperature is -40°C~85°C TA. A flip flop of this type is classified as a D-Type. JK flip flop belongs to the 74ABTseries of FPGAs. You should not exceed 150MHzin the output frequency of the device. In total, there are 2 elements. There is a consumption of 2mAof quiescent energy. The 74ABT16374 family contains it. The input capacitance of this T flip flop is 5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. There is an electronic part mounted in the way of Surface Mount. As you can see from the design, it has pins with 48. There is a clock edge trigger type of Positive Edgeon this device. The design is based on 16bits. Its superior flexibility is attributed to its use of 8 circuits. The supply voltage should be maintained at 5V for high efficiency. There are 3 output lines in this JK flip flop. As of now, there are 2input lines. The high level output current is set to -32mA. There is no low level output current set at 64mA. Ideally, the operating temperature should be below 85°C. Ideally, the operating temperature should be higher than -40°C. In order for it to operate, a supply voltage of 4.5Vis required. 5.5Vis its maximum supply voltage. A frequency of 150MHzcan be achieved.

74ABT16374CSSC Features

Tube package
74ABT series
48 pins
16 Bits

74ABT16374CSSC Applications

There are a lot of ON Semiconductor 74ABT16374CSSC Flip Flops applications.

• Modulo – n – counter
• Asynchronous counter
• ESCC
• Data Synchronizers
• Guaranteed simultaneous switching noise level
• Clock pulse
• Consumer
• CMOS Process
• Supports Live Insertion
• Matched Rise and Fall