74ACTQ273SJ Overview

The flip flop is packaged in 20-SOIC (0.209, 5.30mm Width). The Tubepackage contains it. The output it is configured with uses Non-Inverted. There is a trigger configured with Positive Edge. Surface Mountis in the way of this electric part. A 4.5V~5.5Vsupply voltage is required for it to operate. In this case, the operating temperature is -40°C~85°C TA. D-Typeis the type of this D latch. In terms of FPGAs, it belongs to the 74ACTQ series. It should not exceed 189MHzin terms of its output frequency. D latch consists of 1 elements. Despite external influences, it consumes 40μAof quiescent current. The 74ACTQ273 family contains this object. Its input capacitance is 4.5pFfarads. A part of the electronic system is mounted in the way of Surface Mount. It is designed with 20 pins. In this device, the clock edge trigger type is Positive Edge. 8bits are used in its design. Its superior flexibility is attributed to its use of 8 circuits. In order to ensure high efficiency, the supply voltage should remain at 5V. To operate, the chip has a total of 8 output lines. It has 8lines. There is -24mA output current at the high level. In the low level output current setting, 24mAis used. If the operating temperature is lower than 85°C, it is recommended. Operating temperatures should be above -40°C. In order for it to operate, a supply voltage of 4.5Vis required. It supports a maximum supply voltage of 5.5V volts. The frequency can be set to 189MHz.

74ACTQ273SJ Features

Tube package
74ACTQ series
20 pins
8 Bits

74ACTQ273SJ Applications

There are a lot of ON Semiconductor 74ACTQ273SJ Flip Flops applications.

• Buffered Clock
• Test & Measurement
• Memory
• Functionally equivalent to the MC10/100EL29
• ATE
• Registers
• Modulo – n – counter
• Latch
• Bus hold
• Digital electronics systems