74F374SCX Overview

The item is packaged in 20-SOIC (0.295, 7.50mm Width)cases. The Tape & Reel (TR)package contains it. The output it is configured with uses Tri-State, Non-Inverted. This trigger is configured to use Positive Edge. Surface Mountis positioned in the way of this electronic part. A voltage of 4.5V~5.5Vis required for its operation. A temperature of 0°C~70°C TAis used in the operation. This electronic flip flop is of type D-Type. JK flip flop is a part of the 74Fseries of FPGAs. You should not exceed 140MHzin its output frequency. In total, it contains 1 elements. This process consumes 86mA quiescents. The object belongs to the 74F374 family. Electronic part Surface Mountis mounted in the way. This board is designed with 20pins on it. It has a clock edge trigger type of Positive Edge. Flip flops designed with 8bits are used in this part. 8 circuits are used to achieve its superior flexibility. For high efficiency, the supply voltage should be set to 5V. There are no output lines on the JK flip flop. It has 8lines. There is -3mA output current at the high level. 24mAis set as the low level output current. It is recommended that the operating temperature be below 70°C. If the operating temperature is higher than 0°C, the system should operate properly. Initially, it requires a voltage of 4.5V as the minimum supply voltage. There is a maximum voltage support of 5.5V. It is possible to achieve 140MHz frequencies.

74F374SCX Features

Tape & Reel (TR) package
74F series
20 pins
8 Bits

74F374SCX Applications

There are a lot of ON Semiconductor 74F374SCX Flip Flops applications.

• Balanced 24 mA output drivers
• EMI reduction circuitry
• Divide a clock signal by 2 or 4
• Bus hold
• Modulo – n – counter
• Balanced Propagation Delays
• Instrumentation
• ESD protection
• Shift Registers
• Pattern generators