74LCX16821MTDX Overview

The package is in the form of 56-TFSOP (0.240, 6.10mm Width). Package Tape & Reel (TR)embeds it. T flip flop is configured with an output of Tri-State, Non-Inverted. The trigger it is configured with uses Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. A 2V~3.6Vsupply voltage is required for it to operate. In this case, the operating temperature is -40°C~85°C TA. A flip flop of this type is classified as a D-Type. In FPGA terms, D flip flop is a type of 74LCXseries FPGA. Its output frequency should not exceed 150MHz. This D latch belongs to the family of 74LCX16821. A JK flip flop with a 7pFfarad input capacitance is used here. Surface Mount mounts this electronic component. With its 56pins, it is designed to work with most electronic flip flops. This device's clock edge trigger type is Positive Edge. An electronic part with 20bits has been designed. It operates with 3 output lines. This input has 2lines. There is 20μA quiescent current consumption by it.

74LCX16821MTDX Features

Tape & Reel (TR) package
74LCX series
56 pins
20 Bits

74LCX16821MTDX Applications

There are a lot of ON Semiconductor 74LCX16821MTDX Flip Flops applications.

• Consumer
• Shift Registers
• Test & Measurement
• Data storage
• Safety Clamp
• Data Synchronizers
• Communications
• Single Down Count-Control Line
• Latch-up performance
• Parallel data storage