DM74ALS175MX Overview

The flip flop is packaged in 16-SOIC (0.154, 3.90mm Width). The package Tape & Reel (TR)contains it. It is configured with Differentialas an output. This trigger is configured to use Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. A supply voltage of 4.5V~5.5V is required for operation. 0°C~70°C TAis the operating temperature. This logic flip flop is classified as type D-Type. The FPGA belongs to the 74ALS series. You should not exceed 50MHzin its output frequency. In total, there are 1 elements. During its operation, it consumes 14mA quiescent energy. The 74ALS175 family contains this object. The electronic part is mounted in the way of Surface Mount. 16pins are included in its design. In this device, the clock edge trigger type is Positive Edge. An electronic part with 4bits has been designed. Due to its superior flexibility, it uses 4 circuits. In order to achieve high efficiency, the supply voltage should be maintained at 5V. It operates with 4 output lines. As of now, there are 4input lines. In this case, the high level output current is set to -400μA. In the low level output current setting, the current is set to 8mA. It is recommended that the operating temperature be below 70°C. It is recommended that the operating temperature be greater than 0°C. The system operates with a minimum supply voltage of 4.5V. In this case, it supports a maximum supply voltage of 5.5V. It is possible to achieve 50MHz frequencies.

DM74ALS175MX Features

Tape & Reel (TR) package
74ALS series
16 pins
4 Bits

DM74ALS175MX Applications

There are a lot of ON Semiconductor DM74ALS175MX Flip Flops applications.

• Frequency Divider circuits
• 2 – Bit synchronous counter
• Control circuits
• Buffered Clock
• Event Detectors
• Set-reset capability
• Communications
• Counters
• Modulo – n – counter
• Frequency Dividers