MC74ACT574DW Overview
20-SOIC (0.295, 7.50mm Width)is the way it is packaged. A package named Tubeincludes it. Currently, the output is configured to use Tri-State, Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. Surface Mountis occupied by this electronic component. A voltage of 4.5V~5.5Vis used as the supply voltage. Temperature is set to -40°C~85°C TA. D-Typedescribes this flip flop. JK flip flop is a part of the 74ACTseries of FPGAs. Its output frequency should not exceed 100MHz Hz. In total, it contains 1 elements. During its operation, it consumes 8μA quiescent energy. There are 20 terminations,D latch belongs to the 74ACT574 family. The power supply voltage is 5V. This T flip flop has a capacitance of 4.5pF farads at the input. ACTis the family of this D flip flop. A part of the electronic system is mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. It has a clock edge trigger type of Positive Edge. The part you are looking for is included in FF/Latches. An electronic part with 8bits has been designed. There is a 5.5Vmaximum supply voltage (Vsup). Normal operation requires a supply voltage (Vsup) above 4.5V. In order for the device to operate, it requires 5V power supplies. The D flip flop is embedded with 2ports. It operates with 3 output lines. As of now, there are 8input lines.
MC74ACT574DW Features
Tube package
74ACT series
20 pins
8 Bits
5V power supplies
MC74ACT574DW Applications
There are a lot of ON Semiconductor MC74ACT574DW Flip Flops applications.
- Patented noise
- Guaranteed simultaneous switching noise level
- Balanced 24 mA output drivers
- Instrumentation
- Data storage
- Communications
- Circuit Design
- Safety Clamp
- Bounce elimination switch
- CMOS Process
