As the electronic part is packed in 16-SOIC (0.154, 3.90mm Width), international shipping is convenient. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. Surface Mount is where this multiplexer is located. 1:1 is the ratio of multiplexer to demultiplexer circuits. An extended operating temperature of -55°C~125°C TA degrees Celsius. 16 terminations have been made so far. By its 1 channels, the electronic component provides high-quality output. An 4.5V voltage supply should allow the electrical part to be turned on and run. 16 pins are injected to the electronic part body. A SPST - NO/NC switching circuit is used for these analog switches. Try searching with MC74HC4316A if you're looking for variants. In this multiplexer, the internal resistance is 160Ohm. The datasheets for the 16 pins explain the functions. Theswitch device is a typical Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 6V to the switch device in normal circumstances. The digital multiplexer has a low cost Dual supply. 2V is the lowest voltage the electrical component should receive. In order to operate this switch device, it would need a current of 40μA. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 6V. The voltage should be at least 1V if you are using dual power supplies. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. A 4 input needs to be operated. In 150MHz-bandwidths, data can be transferred.