The electronic component is convenient to ship overseas because it is packed in a 16-SOIC (0.209, 5.30mm Width). In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. In Surface Mount, this analog switch is mounted. 1:1 is the ratio of multiplexer to demultiplexer circuits. Operating temperature around -55°C~125°C TA extended. In total, there have been 16 terminations. The electronic part delivers high-quality output through its 1 channels. When a voltage supply of 4.5V is used, the electronic component should be turned on and run. There is an electrical component included in the 16 series. The analog switch ics are built using SPST - NO/NC switching circuits. Try searching for MC74HC4316A variants of the analog switch ic. Analog switches have 130Ohm internal resistance. To find out what the 16 pins do, please refer to the datasheets. There is Multiplexers or Switches analog multiplexer like this in the world. It is generally not recommended to supply a voltage higher than 6V to the switch device in normal circumstances. The digital multiplexer has a low cost Dual supply. In order for the electronic part to function properly, the lowest voltage should be 2V. It would be sufficient to run this analogue multiplexer with 40μA current. Despite this switch device's dual supply capability, its voltage should not exceed 6V. If you are using dual power supplies, you should attach at least 1V. There are SEPARATE OUTPUT outputs on this analog switch ic. The 4 inputs need to be operated in order to work. There are various bandwidths available for data transfer.