MC74VHCT374ADTRG Overview

It is packaged in the way of 20-TSSOP (0.173, 4.40mm Width). A package named Tape & Reel (TR)includes it. T flip flop is configured with an output of Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. Surface Mountis in the way of this electric part. It operates with a supply voltage of 4.5V~5.5V. It is operating at -40°C~85°C TA. This D latch has the type D-Type. JK flip flop is a part of the 74VHCTseries of FPGAs. Its output frequency should not exceed 130MHz Hz. In total, it contains 1 elements. During its operation, it consumes 4μA quiescent energy. It has been determined that there have been 20 terminations. This D latch belongs to the family of 74VHCT374. The power source is powered by 5V. Its input capacitance is 4pF farads. AHCT/VHCTis the family of this D flip flop. Surface Mount mounts this electronic component. This board is designed with 20pins on it. A Positive Edgeclock edge trigger is used in this device. The RS flip flops belongs to FF/Latches base part number. The flip flop is designed with 8bits. The superior flexibility of this circuit is achieved by using 8 circuits. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. A total of 5V power supplies are needed to run it. The D flip flop has no ports embedded. In order to ensure high efficiency, the supply voltage should remain at 5V. The JK flip flop is with 3 output lines to operate.

MC74VHCT374ADTRG Features

Tape & Reel (TR) package
74VHCT series
20 pins
8 Bits
5V power supplies

MC74VHCT374ADTRG Applications

There are a lot of ON Semiconductor MC74VHCT374ADTRG Flip Flops applications.

• Dynamic threshold performance
• Computers
• Single Up Count-Control Line
• Instrumentation
• Memory
• Storage registers
• Divide a clock signal by 2 or 4
• Supports Live Insertion
• Load Control
• Data Synchronizers