SA5534ADR2G Overview
In order to protect the op amps, a 8-SOIC (0.154, 3.90mm Width) case is used. General Purpose-type instrumentation amplifiers are used in this application. A Tape & Reel (TR) case is used to deliver the buffer op amp. A total of 8 terminations have been reported in the past few weeks. A total of 8 pins are attached to buffer op amp. I would like you to keep in mind that this buffer amplifier needs to be run at a voltage of 15V. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. In total, the buffer amplifier consists of 8 pins. As far as the input offset voltage is concerned, linear amplifier rates at 4mV. This electronic component is recommended to be mounted using the mounting type Surface Mount. It is important to note that this linear amplifier works well at a temperature of -40°C~85°C when it comes to operating temperatureAs long as the supply current of the chip does not exceed 4mA, this op amp ic can operate. Keeping the voltage gain at 100dB is the best course of action. The buffer op amp is rated for an operating voltage of 1 when it comes to the power supply. The linear amplifier is packaged by using a TAPE AND REEL axis.
SA5534ADR2G Features
8 Pins
supply voltage of 15V
100dB voltage gain
SA5534ADR2G Applications
There are a lot of ON Semiconductor SA5534ADR2G Instrumentational OP Amps applications.
- Digital cameras
- Large motor controllers
- Car stereo
- Biopotential
- Inverse/same-phase proportional circuit
- ECG equipment
- single/dual op amp sum and difference circuits
- High/low-pass filter circuit
- Proportional counter tubes
- Addition operation circuits
