The electronic part can be shipped overseas conveniently because it is packaged in 16-LSSOP (0.173, 4.40mm Width). This packaging method provides high reliability because it uses advanced packaging techniques. It is mounted in the position Surface Mount. Multiplexers and demultiplexers have the same number of circuits 2:1. Extended operating temperature around -40°C~85°C TA. There are 16 terminations totally. This electronic part offers high-quality output due to its 2 channels. When the electronic component is given a voltage of 5V, it should be turned on and run. The electronic part body is injected with 16 pins. These analog multiplexers are built based on SPDT switching circuits. Circuits number 3 make up this analogue multiplexer. BU4053 can be used to search for analog multiplexer variants. Internally, this switch multiplexer has a resistance of 160Ohm. Datasheets for 16 pin functions are available upon request. The analog multiplexer shown here is a typical Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 18V to the switch device in normal circumstances. A cost-effective Single supply type analogue multiplexer. The lowest voltage fed to the electronic component should be 3V. This digital switch can be operated with a current of 15μA. This analog switch requires a voltage of 3V~18V to drain from a single voltage supply. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 9V. In the case of dual power supplies, you should connect at least 1.5V. An analog IC with the number DIFFERENTIAL MULTIPLEXER is integrated into this board. It is possible to transfer data over a 20MHz-bandwidth.
BU4053BCFV-E2 Features
2 Channels Switch Circuit: SPDT 15μA Supply Current Bandwidth: 20MHz
BU4053BCFV-E2 Applications
There are a lot of ROHM Semiconductor BU4053BCFV-E2 Analog Switches & Multiplexers ICs applications.