74VHC74TTR Overview

As a result, it is packaged as 14-TSSOP (0.173, 4.40mm Width). It is contained within the Tape & Reel (TR)package. T flip flop uses Differentialas its output configuration. This trigger is configured to use Positive Edge. There is an electronic component mounted in the way of Surface Mount. The supply voltage is set to 2V~5.5V. It is operating at -55°C~125°C TA. This logic flip flop is classified as type D-Type. In FPGA terms, D flip flop is a type of 74VHCseries FPGA. There should be no greater frequency than 115MHzon its output. A total of 14terminations have been recorded. This D latch belongs to the family of 74VHC74. An input voltage of 3.3Vpowers the D latch. The input capacitance of this T flip flop is 7pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. In terms of electronic devices, this device belongs to the AHC/VHCfamily of devices. It is mounted by the way of Surface Mount. With its 14pins, it is designed to work with most electronic flip flops. The clock edge trigger type for this device is Positive Edge. This part is included in FF/Latches. It reaches 5.5Vwhen the maximum supply voltage (Vsup) is applied. For normal operation, the supply voltage (Vsup) should be above 2V. To achieve this superior flexibility, 2 circuits are used. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. There are 1 output lines in this JK flip flop. This D latch consumes 2μA quiescent current at all.

74VHC74TTR Features

Tape & Reel (TR) package
74VHC series
14 pins

74VHC74TTR Applications

There are a lot of STMicroelectronics 74VHC74TTR Flip Flops applications.

• Buffer registers
• Modulo – n – counter
• Balanced Propagation Delays
• Guaranteed simultaneous switching noise level
• Data transfer
• Set-reset capability
• 2 – Bit synchronous counter
• Digital electronics systems
• Memory
• Data Synchronizers