CY74FCT574TSOCT Overview

It is embeded in 20-SOIC (0.295, 7.50mm Width) case. It is contained within the Tape & Reel (TR)package. As configured, the output uses Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. This electronic part is mounted in the way of Surface Mount. Powered by a 4.75V~5.25Vvolt supply, it operates as follows. The operating temperature is -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. In FPGA terms, D flip flop is a type of 74FCTseries FPGA. In total, it contains 1 elements. As a result, it consumes 200μA of quiescent current without being affected by external factors. The number of terminations is 20. JK flip flop belongs to 74FCT574 family. The power supply voltage is 5V. A JK flip flop with a 5pFfarad input capacitance is used here. Electronic devices of this type belong to the FCTfamily. There is an electronic part that is mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. Flip flops designed with 8bits are used in this part. There is a 5.25Vmaximum supply voltage (Vsup). Normally, the supply voltage (Vsup) should be above 4.75V. Its flexibility is enhanced by 8 circuits. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TAPE AND REEL. The D latch runs on a voltage of 5V volts. The flip flop contains 2ports. There are no output lines on the JK flip flop.

CY74FCT574TSOCT Features

Tape & Reel (TR) package
74FCT series
20 pins
8 Bits
5V power supplies

CY74FCT574TSOCT Applications

There are a lot of Texas Instruments CY74FCT574TSOCT Flip Flops applications.

• Buffered Clock
• Power down protection
• Modulo – n – counter
• Event Detectors
• CMOS Process
• ESD protection
• Single Down Count-Control Line
• Convert a momentary switch to a toggle switch
• Parallel data storage
• Load Control