TL062ACN Overview

It is packaged in an 8-DIP (0.300, 7.62mm)-case that protects the operational amplifiers from damage. J-FET-type instrumentation amplifiers are used in this application. A Tube case is used for delivering the op amp. We are approaching the 8h termination of the year. Linear amplifier has a total of 8 pins. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. A type of Operational Amplifier op amp ic can be identified by the fact that this is a type of Operational Amplifier device. In total, the buffer amplifier consists of 8 pins. There is an input offset voltage of 6mV for this buffer op amp. This electronic part is recommended for mounting type Through Hole. According to the manufacturer, this buffer op amp works well at 0°C~70°C , which is a good operating temperature. An 200μA volt supply current is needed for this linear amplifier to operate. 75.56dB should remain the voltage gain. The op amp is rated for an operating supply voltage of 2. The operating supply voltage of the buffer op amp is rated at 18V.

TL062ACN Features

8 Pins
supply voltage of 15V
75.56dB voltage gain

TL062ACN Applications

There are a lot of STMicroelectronics TL062ACN Instrumentational OP Amps applications.

• PDA
• Inverse/same-phase proportional circuit
• Switching amplifier
• Vehicle electronics
• Broadcasting
• Multiplication circuits
• Biopotential
• Addition operation circuits
• Cinema or auditorium audio system
• earphone