This electronic part is conveniently packaged in SOT-23-6, making it easy to ship abroad. High reliability is provided by advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. The ratio between the number of multiplexer and demultiplexer circuits is 2:1. Extended operating temperature around -40°C~125°C TA. There are 6 terminations totally. By its 1 channels, the electronic component provides high-quality output. It is safe to turn on and run the electronic component with a 2.3V voltage supply. Electronic part bodies are injected with 6 pins. A SPDT switching circuit is used for these analog switches. Look for analog switch ic variants by searching with 1G3157. It has an internal resistance of 15Ohm. The datasheets for the 6 pins explain the functions. This switch device is a typical Multiplexer or Switches. Users should never supply a voltage higher than 5.5V to a switch device. The analog switch ic is of the Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 1.65V. In order to operate this switch device, it would need a current of 1μA. A voltage of 1.65V~5.5V is required for this switch device, which drains from a single voltage source. A voltage higher than 10μA may cause damage to the switch multiplexer. There are 1 inputs to be operated. 300MHz bandwidths enable data to be transferred. Resistivity from Drain to Source is 15Ohm for this electronic part. 2 outputs are included in the analogue multiplexer. It is capable of carrying out 2-bit operation. The series starts with Automotive, AEC-Q100.