Shipping overseas is convenient with the electronic component packed in 16-TSSOP (0.173, 4.40mm Width). A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. 2:1 is the ratio between multiplexers and demultiplexers. Extended operating temperature around -55°C~125°C TA. The total number of terminations is 16. The electronic part delivers high-quality output through its 2 channels. An 5V voltage supply should allow the electrical part to be turned on and run. It is injected into the electrical part body with 16 pins. On the other hand, analog switches can be constructed using SPDT switching circuits. 3 circuits are used in this analogue multiplexer. Use CD4053 to search for variants of the digital switches. As far as internal resistance is concerned, it has 240Ohm. You can find the functions of the 16 pins in the datasheets. This switch device is a typical Multiplexer or Switches. Users shouldn't supply more than 20V voltage to the switch device. The digital multiplexer has a low cost Dual, Single supply. 3V should be the lowest voltage fed to the electronic component. The analogue multiplexer could operate on 80nA current. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 9V. When using dual power supplies, you should attach at least 2.5V. It is integrated with a SINGLE-ENDED MULTIPLEXER analog IC. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. 18V operating voltages can be used with this electrical part. Operating 6 inputs is required. The data can be transferred over a wide range of bandwidths, called 30MHz bandwidths.
CD4053BPWRG4 Features
2 Channels Switch Circuit: SPDT 80nA Supply Current Bandwidth: 30MHz
CD4053BPWRG4 Applications
There are a lot of Texas Instruments CD4053BPWRG4 Analog Switches & Multiplexers ICs applications.