CD74ACT273MPWREP Overview

It is embeded in 20-TSSOP (0.173, 4.40mm Width) case. The Tape & Reel (TR)package contains it. As configured, the output uses Non-Inverted. This trigger uses the value Positive Edge. The electronic part is mounted in the way of Surface Mount. The JK flip flop operates at 4.5V~5.5Vvolts. It is operating at -55°C~125°C TA. A flip flop of this type is classified as a D-Type. JK flip flop belongs to the 74ACTseries of FPGAs. A frequency of 85MHzshould not be exceeded by its output. In total, it contains 1 elements. There is a consumption of 8μAof quiescent energy. The 74ACT273 family contains it. It is mounted by the way of Surface Mount. As you can see from the design, it has pins with 20. This device has Positive Edgeas its clock edge trigger type. The high level output current is set to 24mA. A 24mAvalue is set for low-level output current. Ideally, the operating temperature should be below 125°C. In order for the system to operate properly, the temperature should be higher than -55°C. This frequency can be achieved 85MHz.

CD74ACT273MPWREP Features

Tape & Reel (TR) package
74ACT series
20 pins

CD74ACT273MPWREP Applications

There are a lot of Texas Instruments CD74ACT273MPWREP Flip Flops applications.

• Individual Asynchronous Resets
• Consumer
• Single Down Count-Control Line
• Communications
• ESCC
• Latch-up performance
• Modulo – n – counter
• Test & Measurement
• Balanced 24 mA output drivers
• Parallel data storage