The electronic component is convenient to ship overseas because it is packed in a 16-TSSOP (0.173, 4.40mm Width). High reliability is provided by advanced packaging method Tube. In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have a ratio of 4:1. An extended operating temperature of -55°C~125°C TA degrees Celsius. There are 16 terminations totally. As a result of its 8 channels, this electronic component provides high-quality output. A 4.5V voltage supply should turn on and run the electronic component. There is an electrical component included in the 16 series. The analog switch ics are built using SP4T switching circuits. The circuits in this analogue multiplexer number 2. Try searching for 74HC4052 variants of the analog switch ic. This digital multiplexer has 130Ohm internal resistance. For details about the functions of 16 pins, please refer to the datasheets. Multiplexer or Switches is a typical switch device. normally, users should not supply switches with voltages higher than 6V. The analog switch ic is of the Dual, Single supply type and is cost-effective. There should be 2V voltage fed to the electrical part below 2V. Despite this switch's dual supply capability, its voltage should not exceed 5V. A dual power supply should have at least 1V voltage attached. A DIFFERENTIAL MULTIPLEXER analog IC is integrated into the board. There are 185MHz bandwidths for data transfer. 4-bit operation is possible.