This electronic part is conveniently packaged in 16-TSSOP (0.173, 4.40mm Width), making it easy to ship abroad. High reliability is ensured by the advanced packaging method Cut Tape (CT). In Surface Mount, you'll find this switch device. 2:1 is the number of circuits in the multiplexer and demultiplexer. Operation at a temperature around -55°C~125°C TA. The total number of terminations is 16. By its 2 channels, the electronic component provides high-quality output. In the case of a voltage supply of 4.5V volts, the electrical part can be powered up and run. As part of its design, the 16 series is equipped with this electronic component. SPDT switching circuits are used in these analog switch ics. 3 circuits are used in this analogue multiplexer. If you are looking for variants of the digital switch, trying search with 74HC4053. Internally, this switch multiplexer has a resistance of 130Ohm. Please refer to the datasheets for 16 pins functions. There is a standard Multiplexer or Switches analogue multiplexer here. A voltage higher than 6V should not normally be supplied to the switches. The digital multiplexer has a low cost Dual, Single supply. 2V is the lowest voltage the electrical component should receive. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 5V. With dual power supplies, you should attach at least 1V. An analog IC with the number SINGLE-ENDED MULTIPLEXER is integrated into this board. A 6 input needs to be operated. There are 200MHz bandwidths for data transfer. Drain to Source resistance is 130Ohm.