Due to its 16-SOIC (0.154, 3.90mm Width) packaging, the electronic part is convenient for international shipping. Advanced packaging method Tube is used to provide high reliability. In Surface Mount, you'll find this switch device. The ratio between the number of multiplexer and demultiplexer circuits is 4:1. Extended operating temperature around -55°C~125°C TA. In total, 16 terminations have occurred. A electrical component with 2 channels is capable of high-quality output. If the voltage supply is 4.5V volts, the electrical component should be turned on and run. A total of 16 pins are injected into the electrical part body. Circuits based on SP4T switching are used to construct these analog switch ics. The circuits in this analogue multiplexer number 2. Use 74HCT4052 to search for variants of the digital switches. There is 130Ohm internal resistance in this digital multiplexer. Please refer to the datasheets for 16 pins functions. The analogue multiplexer in this example is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. Digital switch that provides Dual, Single power at a cost-effective price. 4.5V is the lowest voltage the electrical component should receive. If put voltage greater than 5V on the multiplexer, damage may be caused to the device. For dual power supplies, a voltage of at least 1V should be attached. Integrated with an analog IC DIFFERENTIAL MULTIPLEXER. A voltage of 5V can be used to operate the electronic component. It is possible to operate 8 inputs. 185MHz-bandwidths can be used to transfer data between multiplexers. 4-bits are supported.