TS3A5018RGYRG4 Overview

Shipping overseas is convenient with the electronic component packed in 16-VFQFN Exposed Pad. High reliability is provided by advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 2:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 16. High-quality output is provided by the electronic component's 4 channels. If the voltage supply is 2.5V volts, the electrical component should be turned on and run. The electronic part body is injected with 16 pins. A SPDT switching circuit is used to build these analog multiplexers. There are 4 circuits in this multiplexer. Try searching with TS3A5018 if you're looking for variants. There is 10Ohm internal resistance in this digital multiplexer. For functions related to 16 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 3.6V should not normally be supplied to the switches. Analogue multiplexers of the Single supply type that are cost-effective. 1.8V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 2.5μA current would be sufficient. This analog switch requires a voltage of 1.65V~3.6V to drain from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 7μA. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. A 300MHz-bandwidth can be used for data transfer.

TS3A5018RGYRG4 Features

4 Channels
Switch Circuit: SPDT
2.5μA Supply Current
Bandwidth: 300MHz

TS3A5018RGYRG4 Applications

There are a lot of Texas Instruments
TS3A5018RGYRG4 Analog Switches & Multiplexers ICs applications.

• Transmit
• Low-Voltage
• Isolation
• Medical
• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems