Shipping overseas is convenient due to the electrical component's packing in 16-SOIC (0.154, 3.90mm Width). High reliability is provided by advanced packaging method Tape & Reel (TR). This analog switch is mounted in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 2:1. Temperatures around -55°C~125°C TA are extended for operation. Total terminations are 16. High-quality output is provided by the electronic component's 3 channels. When the electronic component is given a voltage of 4.5V, it should be turned on and run. As part of its design, the 16 series is equipped with this electronic component. Based on SPDT switching circuits, these analog multiplexers work. 3 circuits are used in this analogue multiplexer. Try searching with 74HCT4053 to find analog multiplexer variants. There is 130Ohm internal resistance in this digital multiplexer. The functions of 16 pins can be found in the datasheets. There is Multiplexer or Switches analog multiplexer like this in the world. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. The digital multiplexer has a low cost Dual, Single supply. The lowest voltage the electronic part should receive is 4.5V. Despite this switch's dual supply capability, its voltage should not exceed 5V. In the case of dual power supplies, you should connect at least 1V. An analog IC with the number SINGLE-ENDED MULTIPLEXER is integrated into this board. Operating voltages of 5V are compatible with the electrical part. It is possible to operate 6 inputs. 200MHz-bandwidths can be used to transfer data between multiplexers. 2-bits are supported.