Due to its 16-TSSOP (0.173, 4.40mm Width) packaging, the electronic part is convenient for international shipping. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. A switch device like this is mounted in Surface Mount. 2:1 is the ratio of multiplexer to demultiplexer circuits. Operation at a temperature around -40°C~105°C TA. There are 16 terminations totally. The electronic part delivers high-quality output through its 3 channels. When a voltage supply of 2.3V is used, the electronic component should be turned on and run. A total of 16 pins are injected into the body of the electronic part. Circuits based on SPDT switching are used to construct these analog switch ics. There are 3 circuits in this multiplexer. Look for analog switch ic variants by searching with 74LV4053. Internally, this switch multiplexer has a resistance of 75Ohm. For details about the functions of 16 pins, please refer to the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. The analog switch ic is of the Single supply type and is cost-effective. 2V is the lowest voltage that should be fed to the electronic electronic part. For this digital switch to work, 20μA current would suffice. This analogue multiplexer requires a voltage of 2V~5.5V when it drains from a single voltage supply. 50MHz bandwidths enable data to be transferred. It is capable of carrying out 2-bit operation. It comes from the Automotive, AEC-Q100 series.